Jotun 18L Jotashield Colourlast, High Calibre & UV-Protected, Matt WP83

Features

The Distinctive UV-protected colours provide exceptional defence against the sun's corrosive UV rays. Specifically created to endure the severe weather in the Middle East, it offers a tough, long-lasting matt finish with little dirt pickup. Concrete is shielded against carbonation by its special formulation (Acts as anti-carbonation coating).

RECOMMENDED USE:
Perfect for beautifying and safeguarding external surfaces. As a highly effective anti-carbonation coating, JOTASHEILD COLOURLAST JOTUN can also be used in interior spaces like basement parking garage walls and ceilings.

SUBSTRATE:
Cement plaster, concrete, block work, rendered surfaces, gypsum board etc.

Product Data:
Packaging Size: 18L.
Solids by volume: 34 ± 2 volume%.
Specific gravity: 1.31.
VOC: 22 g/l.

APPLICATION DATA:
The product can be applied by.
Roller: Recommended.
Spray: Use airless spray or conventional spray.
Brush: Recommended to paint corners and edges.
Guiding data for airless spray:
Nozzle tip: 0.021–0.027".
Spray angle degrees: 65–80°.
Pressure at nozzle: 140 - 190 kg/cm² (2100 psi).
Cleaning of painting tools:
Water.

TECHNICAL DATA:
Film thickness per coat.
Typical recommended range:
Dry film thickness: 35 - 50 µm.
Wet film thickness: 102 - 147 µm.
Theoretical spreading rate: 9.7 - 6.8 m²/l.
Thinner: Water.
Dilution: Maximum 10%.

CONDITIONS DURING APPLICATION:
The substrate's temperature must be at least 10 °C and at least 3 °C above the air's dew point, as measured close to the substrate. To guarantee adequate drying in small spaces, good airflow is typically needed.

DRYING TIMES:
1. Recoat using the same general type of paint, according to the advice given.
2. When applying multiple coats, drying durations will be impacted by the quantity and order of coats applied, as well as by the total thickness of those coats.
3. Before applying the next coat, the surface must be clean, dry, and free from contaminants.

The drying time is measured by stated values:
Relative Humidity (RH) 50 %
Substrate temperature 10 °C 23 °C 40 °C
Surface (touch) dry: 12 h 6 h 2h.
Hard dry: 16 h 8 h 4 h.
Dry to over coat, minimum: 12 h 6 h 2 h.

RECOMMENDED PAINT SYSTEM:
Primer: Acrylic Emulsion Primer or Jotashield Alkali Resistant Primer or Jotashield Penetrating Primer 1 Coat.
Topcoat: Jotashield Colour Last Matt 2 Coats.

STORAGE:
It is necessary to preserve JOTASHEILD COLOURLAST JOTUN in line with national regulations. Ensure that the containers are kept away from sources of heat and ignite in a dry, cold, well-ventilated area. Containers must always be kept shut. Handle carefully.