Asian Paints Berger, Floor Guard Epoxy Top Coat, 20L Base, 5L Hardener - Flake Grey

Designed Use

• Designed for the mild industrial floor of parking areas and traffic areas and walkways.
• Has good chemical resistance and hot water resistance.
• It is recommended in mild duty areas of walkways, industrial floors, battery rooms and equipment rooms that are not subjected to heavy movements.

Surface Preparation

The surface must be dry and sound, free from breakdowns and contaminants including salt deposits. If the application is to a concrete substrate, it must be sound and free from laitance. Remove laitance by wire brush, acid etch or sweep blast. Any blow holes must be filled with Epilux Solventless filler or floor compound.

• Soluble salts, dirt and dust must be removed prior to applying the coating. Dry brushing should be sufficient. A freshwater wash must follow to remove all soluble salts.
• Always ensure the maximum overcoating time for the primer/build coat has not been exceeded prior to applying the Berger Paint.

Product Use Restrictions

• As is common with all epoxies this product will chalk on exposure to direct sunlight.
• Dry heat resistance up to 120°C.
• Product can also be applied between 50 - 75 microns DFT.

Application Details

Airless Spray: This is the recommended method of application. A maximum of 5% Thinner may be added. Tip Size: 0.38 - 0.48 mm (0.015 - 0.019 in) Pressure should be 130 - 160 kg/cm2 (1800 - 2300 psi).

Brush or Roller: However, additional coats may be required to achieve the recommended film thickness. Thinner (max 2%).